Gadolinium oxide (Gd2O3) Gd2O3

Gd2O3, gadolinium(III) oxide: two gadolinium(III) ions and three oxide ions per formula unit · CAS 12064-62-9 · cubic and monoclinic, C2/m for the monoclinic form (ChemicalBook and Wikipedia); Ia-3 for the cubic form (Wikipedia)

Gadolinium(III) oxide (Gd2O3, also called gadolinia) is a white powder.

8 sources · Updated 2026-11-02 · CC BY 4.0

Evidence level

2 of 5

Lab-measured

Recipe, share of the weight

  • Gd not statedGadolinium
  • O not statedOxygen

Best for

Neutron-absorbing rare-earth oxide in reactor control rods and neutron shields, and as a laser host (Merck Index via PubChem; Wikipedia)

Weakest at

Hygroscopic powder that takes up moisture from air and dissolves in strong acids (Lorad SDS; Wikipedia)

Risk at a glance

  • People None found. Eye irritant (H319); low hazard otherwise
  • If it fails Low. Moisture uptake and caking of the powder
  • Corrosion Moderate. Gd2O3 dissolves in common mineral acids, and the supplier lists strong acids as reactive.

Quick facts: Gd2O3

Key properties of Gd2O3
PropertyValueBasis
Density7.07 to 7.41 g/cm³3 sourced values across conditions
Thermal conductivity10 W/(m·K)1 sourced value
Melting point2,330 to 2,420 °C3 sourced values across conditions
Specific heat294 J/(kg·K)1 sourced value

What is the density of Gadolinium oxide (Gd2O3)?

Gadolinium oxide (Gd2O3) has a density of 7.07 to 7.41 g/cm³. The range covers 3 sourced values across the tempers, forms and test conditions the sources report; room-temperature values are used where a source states a temperature.

What is the thermal conductivity of Gadolinium oxide (Gd2O3)?

Gadolinium oxide (Gd2O3) has a thermal conductivity of 10 W/(m·K). The source and test conditions are listed in the properties table on this page.

What is the melting point of Gadolinium oxide (Gd2O3)?

Gadolinium oxide (Gd2O3) has a melting point of 2,330 to 2,420 °C. The range covers 3 sourced values across the tempers, forms and test conditions the sources report; room-temperature values are used where a source states a temperature.

What is Gadolinium oxide (Gd2O3) used for?

Uses recorded in the sources include Control rods and neutron shields in some nuclear reactors; Solid-state laser host material.

Why it exists

Gadolinium(III) oxide is a white, hygroscopic rare-earth oxide. It is used where a dense, high-melting oxide with neutron-capture chemistry is needed. The supplier SDS gives a density of 7.07 g/cm3 and a melting point above 2,420 °C. The best-documented uses are in control rods and neutron shields, and as a host for solid-state lasers.

Where it's used

Reactor control rods and neutron shields

PubChem's Merck Index entry says the compound is used in control rods in some nuclear reactors, and in neutron shields, catalysts, ceramics, glass, filament coatings, lasers and masers.

Solid-state lasers

Wikipedia says Gd2O3 is a host material in some solid-state lasers, and that when doped with neodymium or erbium it can produce lasers with high efficiency.

Other listed uses

Wikipedia lists the oxide as a potential contrast agent for magnetic resonance imaging, as a material used in some solid oxide fuel cells, and as a constituent of gadolinium derivatives studied for MRI. These are listed uses, not flight uses.

Recipe

Gd2O3, gadolinium(III) oxide: two gadolinium(III) ions and three oxide ions per formula unit

Gadolinium(III) oxide is an ionic oxide built from gadolinium and oxygen. Each formula unit has two gadolinium atoms and three oxygen atoms. Wikipedia says it can be formed by thermal decomposition of the hydroxide, nitrate, carbonate or oxalate, and that it also forms as a surface layer on gadolinium metal.

What Gd2O3 is made of
IngredientShare of the weightWhat it does
Gadolinium Gd not stated The rare-earth ion (Gd3+) in the oxide lattice. The metal tarnishes in moist air to this oxide (Wikipedia).
Oxygen O not stated The oxide ion (O2-) that completes the formula unit.

Weight shares are as printed in the sources.

What it can do

Heat tolerance

The supplier SDS gives a melting point above 2,420 °C, and Wikipedia gives 2,420 °C.

Neutron control

The Merck Index entry in PubChem records use in control rods and neutron shields.

Laser host

Wikipedia says it can host a solid-state laser when doped with neodymium or erbium.

Precursor

Wikipedia says it forms by heating the hydroxide, nitrate, carbonate or oxalate.

How it compares

Gadolinium(III) oxide is what the gadolinium metal turns into in moist air. Wikipedia says the metal tarnishes quickly in moist air and forms a loosely adhering oxide layer. The oxide is a white powder that its supplier classifies for eye irritation only (H319). This file carries no metal values, so the comparison rows below list only this compound's own values.

The same measurements for each material, so you can compare them. Each row names the key condition under the value; the full conditions and methods are in the numbered notes under Technical details.

Benchmarks
MeasurementGd2O3
Thermal behavior and safety
Melting point, Lorad Chemical safety data sheet> 2420 °C3
Melting point, Wikipedia infoboxValue printed in the Wikipedia infobox2420 °C
Melting point, ChemicalBook product page2330 °C4
Thermal conductivity, ChemicalBook product page10.04 W/(m·K)5
Specific heat capacity, crystalValue printed on a reseller's catalogue page0.2943 J/(g·K)
Physical and electrical
Density, Lorad Chemical safety data sheetValue printed in a supplier safety data sheet7.07 g/cm³
Density, Wikipedia infobox7.07 g/cm³1
Density, ChemicalBook product page7.407 g/mL2
Other measurements
Molar mass (formula mass)Value printed in a supplier safety data sheet362.5 g/mol
Lattice parameter a, monoclinic cell as listed1.408 nm6
Lattice parameter b, monoclinic cell as listedValue printed on a reseller's catalogue page0.3571 nm
Lattice parameter c, monoclinic cell as listedValue printed on a reseller's catalogue page0.8764 nm

Why choose it, and why not

Good for

  • Neutron control and shielding, where the oxide's use in control rods is documented (Merck Index via PubChem).
  • Solid-state laser host materials doped with neodymium or erbium (Wikipedia).

Watch out for

  • Hygroscopic: it takes up moisture from air, so keep it sealed and dry.
  • Eye irritant (H319). Aquatic hazard H410 appears in PubChem and Wikipedia but not on the supplier SDS, so check the SDS for the lot you buy.
  • Physical values disagree between sources: density 7.07 g/cm3 (Lorad, Wikipedia) against 7.407 g/mL (ChemicalBook).

Gadolinium(III) oxide is a stable white oxide with a melting point above 2,420 °C, used for neutron control and as a laser host. Its supplier classifies it only for eye irritation, but its moisture uptake and the disagreement between sources on density and melting point need checking before specifying it.

Technical details

For scientists and researchers. Everything above comes from the record below: every number with its method, its conditions and its source.

Notes

The method, full conditions and any caveat for the numbered rows above.

Notes for the numbered rows
#MeasurementMethodConditionsCaveat
1Density, Wikipedia infoboxValue printed in the Wikipedia infobox, which cites a reference for ittemperature not statedcitation Patnaik (2002), as cited in the infobox—
2Density, ChemicalBook product pageValue printed on a reseller's catalogue page; the page does not name its original sourcetemperature 20 °Cnote in source lit.The Wikipedia infobox and the Lorad SDS give 7.07 g/cm3 for the same compound, a difference of about 5 %, and PubChem lists 7.407 with no unit printed.
3Melting point, Lorad Chemical safety data sheetLower bound printed in a supplier safety data sheetpressure not statedunit in source > 2,420 °C (> 4,388 °F)—
4Melting point, ChemicalBook product pageLiterature value printed on a reseller's catalogue pagenote in source lit.—
5Thermal conductivity, ChemicalBook product pageValue printed on a reseller's catalogue page without test conditionstemperature not statedform not statedNo temperature or porosity is stated, so the value cannot be compared with dense ceramic data without the test conditions.
6Lattice parameter a, monoclinic cell as listedValue printed on a reseller's catalogue page; the same page lists both cubic and monoclinic crystal systemsspace group C2/m (as listed)angle beta 100.03 degrees as listed—

Corrosion and compatibility

What happens when it meets other materials and environments.

Corrosion and compatibility
EnvironmentConcernWhat happens
Humid air and open storage low Gd2O3 powder takes up water from moist air, so the supplier asks for storage under inert gas.1
Strong acids moderate Gd2O3 dissolves in common mineral acids, and the supplier lists strong acids as reactive.2
Carbon dioxide in air low As a basic oxide, Gd2O3 reacts readily with carbon dioxide to form carbonates.3
Corrosion details
#EnvironmentDetailsTest conditions
1 Humid air and open storage The Lorad Chemical SDS calls the product hygroscopic and says to store it under inert gas. No weight-gain rate or humidity threshold is given in any source read. form powderexposure ambient storage; time and humidity not stated
2 Strong acids Wikipedia says the oxide dissolves in common mineral acids. The Lorad SDS lists strong acids under Reacts with in its reactivity section. No dissolution rate is given. basis qualitative; acid strength and temperature not stated
3 Carbon dioxide in air Wikipedia says the oxide reacts readily with carbon dioxide to form carbonates, and that salt coatings such as oxalate, fluoride, sulfate and phosphate can slow its dissolution in acid. No rate is given. basis qualitative

Risks and side effects

Hazards to people, what happens when a cell overheats, and how the material is handled and stored.

For people

The supplier classifies the oxide only for serious eye irritation. PubChem's company notifications add two aquatic hazard statements, which the supplier SDS does not list.

Eyes
Causes serious eye irritation (H319). The Lorad SDS advises safety glasses with side shields and thorough rinsing with water after eye contact.
Dust
Avoid forming dust. The Lorad SDS says further processing of the solid may form combustible dust, so the dust risk is checked before any processing.
Water environment
PubChem's ECHA summary gives H400 at 40.5% and H410 at 40.5% of notifications, both for very toxic to aquatic life. The Wikipedia infobox lists H319 and H410.

If the powder gets damp

Gd2O3 takes up water from moist air. The supplier's storage advice is designed around that.

Storage
The Lorad SDS says to keep the container tightly closed in a dry, well-ventilated place, under inert gas.
Acids
Wikipedia says the oxide dissolves in common mineral acids, and the Lorad SDS lists strong acids as reactive with it.

Test details
The original wording and numbers from the sources, for readers who want them.

Failure risks

Failure risks
FailureTrigger and consequence
Moisture uptake and caking of the powderlow severityStorage in humid air or in an open containerThe powder is hygroscopic, so it takes up water and its handling and weight change. None of the sources read quantifies the uptake.
Dissolution in acidslow severityContact with common mineral acids or strong acidsThe oxide dissolves and forms the salts of gadolinium, which changes the material. The rate is not quantified in any source read.

Side effects on surrounding parts

Side effects on surrounding parts
AffectsEffect
Dust handling and processing equipmentThe Lorad SDS says further processing of the solid may form combustible dust, and that the potential for combustible dust must be considered before any additional processing.

Handling and storage

  • Store in a tightly closed container in a dry, well-ventilated place, under inert gas. Avoid dust formation and provide exhaust ventilation where dust forms.
  • Wear safety glasses with side shields. Where nuisance dust is a concern, use a respirator approved to N95 (US) or P1 (EU EN 143) standards.

Mitigations

  • Store under inert gas in a dry place, in sealed containers, to limit moisture uptake.

Supply and geography

How common the raw materials are and where they come from.

Rare earths (gadolinium is not reported separately by USGS)

About 6.2 mg/kg in the Earth's crust for the element gadolinium (Wikipedia)

Top producers (2025)
China 69.2%, United States 13.1%, Australia 7.4%, Burma 5.6%
Recycling
USGS: limited quantities of rare earths were recovered from batteries, permanent magnets and fluorescent lamps.
Substitutes
USGS: substitutes are available for many applications but generally are less effective.

Updated